The ORTF stereo microphone technique uses two cardioid mics with their capsules 17 cm apart and angled 110° from each other. The result is a natural, wide-but-focused stereo image that works on drum overheads, acoustic ensembles, pianos and ambiences.
ORTF was developed at the French national broadcaster (Office de radiodiffusion-télévision française) as a way to mimic how human hearing locates sound. It's a go-to setup for good reason: it's quick to rig, forgiving in most rooms and sounds right on playback. Here's what you need to know to use it well.
How ORTF Works
ORTF is a near-coincident technique. It blends the two cues our ears use to place sounds:
- Level difference. Each cardioid points 55° off the centre line. A source on the left hits the left mic more on-axis, so it's louder there.
- Time difference. With capsules about 17 cm apart (roughly the distance between your ears), sound reaches one mic a fraction of a millisecond before the other.
Combining both cues gives a more open, spacious image than a coincident pair, while staying far more mono-friendly than widely spaced mics. The pair's useful recording angle is about 95° in front of it: anything at the edges of that zone will image hard left or hard right on playback.
What you need: two identical cardioid mics (a matched pair is ideal), a stereo bar with markings, and two clean preamp channels with matched gain. Small-diaphragm condensers are the classic choice because they're compact and consistent off-axis.
ORTF vs XY, AB and NOS
A quick orientation to the main stereo pairs:
- XY: two cardioids with capsules stacked together, usually at 90°. Rock-solid mono compatibility and precise imaging, but a narrower image with less sense of space.
- AB (spaced pair): two mics, often omnis, set apart. Big, airy sound with full low end, but vaguer localization and possible phase issues when summed to mono.
- NOS: the Dutch broadcaster's variant, two cardioids at 90° spaced 30 cm apart. Slightly wider than ORTF with a bit less centre focus.
- ORTF: the middle ground. Wide enough to feel alive, precise enough to place each instrument.
For a deeper side-by-side with use cases, see our full stereo microphone techniques comparison.
When to Reach for ORTF
ORTF earns its place in these situations:
- Drum overheads. It captures the whole kit with a coherent image and good cymbal spread, without the hole in the middle a poorly set spaced pair can create.
- Acoustic ensembles. Choirs, string quartets, folk bands. Positioned at the sweet spot in the room, it gives a faithful snapshot of the group.
- Piano. A few feet back from an open lid, it balances hammer attack with body and resonance.
- Ambiences and field recording. For film post-production or game audio, an ORTF recording of a street, park or crowd gives you a believable stereo bed that sits well under dialogue and effects.
- Live capture. Alongside close mics, a well-placed ORTF pair brings in the room and the audience.
It's less ideal in a bad-sounding room, since it picks up a lot of reflections, or when you need a tight, bulletproof mono image. In those cases, XY is the safer call.
Common ORTF Mistakes
- Measuring the wrong spacing. The 17 cm is between the capsules, not the mic bodies or clips.
- Mixing different mic models. Mismatched mics colour each side differently and skew the image. Use an identical pair.
- Unmatched preamp gain. A few dB of difference shifts the whole image. Check levels with a source dead centre.
- Getting too close. Too near a wide source and everything spreads to the extreme edges. Back up until the source fits within the recording angle.
- Ignoring the room. ORTF hears the room. If the space sounds boxy or ringy, treat it or move closer. Our guide to room acoustics for tracking covers practical fixes.
- Skipping the mono check. ORTF folds down well, but always listen in mono before you commit.
Hands-On Exercise: Hear the Difference
Try this at home or in a studio:
- Mount two identical cardioids on a stereo bar: capsules 17 cm apart, angled 55° each side of centre (110° total).
- Set the pair in the middle of a room at ear height.
- Have someone walk slowly in a half-circle in front of the mics, talking or clapping, from far left to far right.
- Record in stereo, panned hard left and right, with no processing.
- Repeat in XY (90°, capsules coincident), then AB if you have omnis.
- Compare: width, how precisely you can locate the speaker, sense of room, and how each one sums to mono.
Write down what you hear. This kind of critical listening builds the reference you'll rely on in every session. If you're setting up at home first, our home studio guide for audio students can help.
ORTF FAQ
Do I need small-diaphragm condensers for ORTF?
No. They're the usual choice because they're compact and even off-axis, but any identical pair of cardioids will work as long as you respect the capsule spacing and angle.
Is ORTF mono compatible?
Reasonably so, and much better than a spaced pair. The 17 cm gap can cause some mild comb filtering in mono, which is why a quick mono check is worth the few seconds.
Can I change the angle or spacing?
You can, but it's no longer strict ORTF. Widening the angle or spacing broadens the image; narrowing them tightens it. Learn the standard first, then experiment.
Learn Stereo Recording in Montreal or Online
Stereo pairs like ORTF are part of the fundamentals covered in Musitechnic's (Collège Unica) A.E.C. in Sound Recording and Design, across recording, mixing and post-production courses. You can study on site in our 8 studios in Westmount or 100% online with live classes and ongoing technical support. Want to see the studios and ask questions? Book a visit or head to Admissions.


